The maintenance of a hydraulic system

                During the first hour of operation. Should carefully check the oil level and detect the leak or the leak has to have the opportunity. Operating temperature must be controlled to no more than 60-70 degrees Celsius during and after working over 50 hours should check Split Cup year and the vertical shaft of the electric motor and pump that is the same center line or not. And check the temperature and pressure of work. During working hours should be controlled and the oil drain, depending on oil properties. Amount and conditions of work of the machine. The oil companies must review and analysis features to determine the right time for the oil drain.

Recommendations on the oil filter and drain when running in normal condition.

- Work 100 hours for full hydraulic system should make a new filter to clean. Or replaced.

- Change your oil every 3000 or 5000 operating hours.

Rules should be implemented to work

- Do not use cotton or similar material to clean.

- Taking oil from the system. Clean or replace filters and clean the tank should be done with caution and circumspection.

- Add oil to a new system.

- As the machine empty on low pressure or no pressure in it is at least 30 minutes for the oil circulation in all parts of the circuit.

- Set a new all

Monitoring of repeat periodically. During the operation. Especially temperature. Higher temperatures result in faster wear of machinery parts than usual. Check oil level and blockage of the filters frequently than usual. Including the observation volume, which indicates disorders caused or is about to happen.

Stop the machine in a short time if not more than two months do not need to measure anything special. Stop the machine in the long run. Operation should be periodically With the pump walk unarmed without pressure in order to lubricate the best in the regular and Rod should be in a position shrink or a K strip º anti corrosion in case of discontinuation of machinery. that already.